Abort from FLGAUS while using GCR source

Dear Sir,

While using the GCR-IONF source, I got an error " Abort called from FLGAUS reason FLGAUS: too much accuracy required Run stopped!
STOP FLGAUS: too much accuracy required"

If I am correct data in .spc have energy range from 0.1 MeV/amu (0.0001 GeV/amu) to 10E6 MeV/amu (10E3 GeV/amu). So if I run the simulation over this complete energy range, it shows this error but if I break this interval into two parts and run the simulation on these two intervals separately, it works fine.

Best regards
ROHIT


GCR_TEST(2).inp (1.7 KB)