Geometry Viewer not found (Mac M1 MacOS 14.1.1)

[luillo (Luigi Salvatore Esposito)]

Dear @ma21171

This error was addressed in this post

Flair on macos M4, issue with interface and geoviewer

Hello @thomas.f Since the update to tk version 8.6.15, MacPort has changed the default variant to +quartz. This is causing the compilation problem and the strange Flair appearance. To fix this, please run the following command to switch to the +x11 variant. sudo port install tk +x11 After that, please recompile geoviewer and test Flair again. Please let us know if this resolves the issue. Cheers, Luigi

Also note that the installation based on Python 3.13 can also have issue.
In that case, I recommend to install Python 3.12 or 3.11:

Flair on macOS Sequoia 15.2

Hello @luillo, Yes, I’m well. I hope you too! Your solution works of course, and gratefully appreciated as always. I took python3 back one step at a time. python312 didn’t work but python311 did. I now have Flair on my Sequoia in full glory. Cheers! mary

Hope this will help.
Please let us know.