Dear Experts,
My model (attached) runs and finishes okay after I cleaned some errors in my geometry. However, it shows “finished with error” when I run it with the spawn setting and doesn’t pop up any error information for me. What should I do? Thank you for your support in advance.
Melike
EarthHill_test.flair (17.3 KB)
Hi @melike.abliz
there is an error in your geometry (undefined space)
see image
Hi Vasilis,
Thanks a lot. These are the errors that were hard for me to locate because all four windows did not show errors. What should I do to find it by myself?
Best Regards,
Melike
Hi Vasilis,
What is the error code 2 points?
With Regards,
Melike
Dear Experts,
What could be the error messages, RC=2 and RC=137 about? Also, how can I see some hidden errors when flair shows no error in my model as in the attached screenshot?
With Regards,
Melike
Changed_Tunnel_Model.flair (16.2 KB)
Dear @melike.abliz,
As it was already said on the forum several times, as example here and here, these error are not generated by Fluka but by your system because a crash occurred. You have to look into the .out .err and .log files that are generated by Fluka to find actual information about the error.
